What edge lifting looks like
Edge lifting starts when the liner no longer stays flush with the guideway at an end, corner or exposed side. You may see a narrow open line, a curled edge, a raised lip under the wiper or a strip that moves when pressed. Delamination is more serious: the bond has separated over an area, sometimes leaving a dull or hollow-looking patch beneath the sheet.
These symptoms matter because a lifted edge can collect oil, chips and coolant. The loose section then becomes a local high spot, changes the running clearance and can spread the failure into sound liner material. Treat the first visible lift as a diagnostic signal rather than trimming it away and returning the machine to service.
Common causes of turcite b delamination
- Oil, grease, moisture or dust remained on the metal guideway before bonding
- The etched bonding face was touched, contaminated or fitted upside down
- The two-part epoxy was mixed incorrectly, applied outside its working time or allowed to cure below its stated temperature
- Clamping pressure was uneven, leaving voids or a weak bond line at the edge
- The bed geometry was not repaired before relining, so movement or local stress loaded the sheet
- Wipers failed and allowed chips or coolant to work under the liner edge
How to diagnose the failure before repair
Repair or full reline?
A small, stable edge defect may be assessed during a planned service, but a loose section should not be patched with a surface adhesive or pressed flat without finding the failed bond. If the liner has lifted over a long edge, shows widespread hollow bonding, has been scored by chips or has lost the required clearance, remove the affected sheet and prepare the bed for a new bonded PTFE liner.
The repair path starts with sound metal geometry. Remove old adhesive, correct scoring or lost alignment, and confirm the measured clearance before selecting turcite b thickness. REALMAX [Turcite B Blue] is one starting option for this application class; the final grade depends on load, speed, lubrication and the machine specification.
Preventing a repeat failure
Use a compatible [Two-Part Epoxy Adhesive] on the prepared etched face, keep both surfaces dry and oil-free, and apply even support across the complete liner during cure. Follow the adhesive datasheet for mixing ratio, working time, minimum temperature and full cure; these values are product-specific and should not be guessed.
After curing, trim and finish the liner to the measured guideway geometry, check contact with spotting paste, restore clean oil grooves and replace damaged wipers. A short inspection record covering bond condition, clearance, lubrication and wiper status turns an edge-lifting incident into useful maintenance information.
Quick answers
Can I glue down a lifted turcite b edge?
Do not simply apply surface glue or press the edge flat. First determine whether contamination, voids, geometry or a failed epoxy bond caused the lift; the correct action may require removing and relining the affected section.
Is turcite b delamination always caused by poor adhesive?
No. Poor preparation or curing is common, but distorted geometry, uneven clamping, contamination under a wiper and excessive local load can also create delamination.
When should I plan a complete slideway reline?
Plan a full reline when lifting is widespread, the bond is hollow across a large area, the liner is scored or the finished clearance can no longer be restored safely with the existing sheet.
Need sheet, adhesive or spotting paste for your machine? Tell us the size and application —we quote within 24 hours.
Request a Quote