Stick-Slip on Your CNC Axis? How to Diagnose Slideway Friction Problems

Maintenance 6 min read · focus: stick slip cnc slideway

What stick-slip tells you about a CNC slideway

Stick-slip is the repeated cycle of an axis holding, then releasing suddenly instead of moving at a steady low feed. On a CNC machine, it often appears as a judder during slow travel, poor surface finish, uneven handwheel movement or an axis that hesitates before moving. The symptom points to changing friction, but it does not identify one single failed part.

A slideway system includes the metal guideway, lubrication film, wipers, adjustment, load and liner material. A bonded PTFE sheet such as a turcite sheet can provide stable low-speed friction, but only when the complete way assembly is clean, lubricated and correctly fitted.

Check the easy causes before opening the way

Do not compensate for a dry or contaminated way by loosening the adjustment. Find the cause first, then set the slideway clearance to the machine maker's procedure.

Separate lubrication, geometry and liner faults

If stick-slip appears only in one travel zone, inspect that section for scoring, lost geometry or a damaged machine tool way liner. If the whole axis behaves the same way, check oil delivery, gib adjustment and load before assuming the liner is at fault. A visual inspection can reveal edge lifting, cracks, polished wear tracks or metal contact, but accurate measurement is needed to confirm guideway condition.

For a slideway repair, first establish whether the metal foundation is sound. Deep scoring or a distorted guideway must be corrected before fitting a new PTFE sheet. The liner thickness should then match the measured clearance and leave enough material for final fitting, scraping guideway contact points and restoring the correct geometry.

When a bonded PTFE liner is the practical fix

A worn liner with stable, repeatable damage can often be addressed during a planned rebuild. The rebuild shop prepares the bed, selects the application-matched turcite b thickness, bonds the etched face with an epoxy adhesive for slideway liner work, then trims and finishes the running surface. [Turcite B Blue] is one REALMAX starting point for this application class; the correct grade depends on load, speed, lubrication and the machine specification.

The repair is not complete when the sheet is glued down. Allow the [Two-Part Epoxy Adhesive] to cure fully, finish the surface to the measured geometry, verify contact with spotting paste and restore clean oil grooves and working wipers. A repeatable inspection record helps the workshop distinguish normal break-in from a new friction problem.

Send REALMAX the machine type, affected axis, way dimensions, current liner thickness, lubrication method and photos of the wear pattern for an application review.

Quick answers

Can stick-slip come from lubrication alone?

Yes. Blocked metering points, incorrect oil, contaminated lubricant or failed wipers can change friction enough to create stick-slip. Check the lubrication path before planning a liner rebuild.

Does a PTFE sheet automatically remove CNC axis judder?

No. A bonded PTFE liner can provide a stable sliding interface, but the bed geometry, clearance, lubrication, load and finishing must all be correct.

What information should I provide for a slideway diagnosis?

Share the machine type, axis, symptom speed, travel position, lubrication method, liner thickness, way dimensions and clear photos of the guideway and liner. These details help separate a maintenance issue from a rebuild requirement.

Related guides

Need sheet, adhesive or spotting paste for your machine? Tell us the size and application —we quote within 24 hours.

Request a Quote